this is the custom g-code i use on my bambu lab p1s and p2s. it parks the nozzle at the wiper and gives it a few proper wipes mid-print. works in both bambu studio and orcaslicer.
important: this code is tailor made for these specific printers. do NOT use it on any other printer, the coordinates are printer-specific. stay near your printer when you test it. i'm not responsible for any misuse of the code, use it at your own responsibility.
step 1
open bambu studio or orcaslicer and insert your stl/object. in this example i just use a cone.

step 2
slice.
step 3
copy the g-code for your printer below.
p1s:
G1 X60 Y264 F15000 ; move to nozzle wipe position
G1 X100 F5000 ; wipe right
G1 X70 F15000 ; wipe left
G1 X100 F5000 ; wipe right
G1 X70 F15000 ; wipe left
G1 X100 F5000 ; wipe right
G1 X70 F15000 ; wipe left
G1 X100 F5000 ; wipe right
G1 X70 F15000 ; wipe left
G1 X60 F5000 ; clearance
p2s:
G0 X55.1 Y240 F20000 ; in front of chute
G0 Y270.5 ; into chute (wiper position)
G91 ; relative
G0 X40 F10000 ; wipe
G0 X-21 F10000
G0 X21 F10000
G0 X-21 F10000
G0 X21 F10000
G0 X-40 F10000
G0 Y-30.5 F15000 ; drive out of chute
G90 ; back to absolute
step 4
drag the vertical slider down to 3 or 4 layers and right-click the plus icon (the little ball). click 'add custom g-code'.

step 5
paste your g-code. again: the code is printer-bound, so don't use the p1s code on any other printer.

step 6
print.

step 7
be AT your printer to check it works. if it does, you can add as many wipes as you want/need: move the vertical layer slider up, right-click, add custom g-code, etc.
done. happy printing <3
